Lamination Operator - 2nd shift
Company: TTM Technologies
Posted on: July 12, 2019
Broad Function: Laminator lays-up I/L cores with pre-preg and
copper foil. Utilizing heat and pressure the booked I/L cores are
pressed to form a panel. Under close to minimum supervision,
depending on assigned job level and skill capability, the Laminator
by applying one or more lamination skills will be able to process
panels through the lamination operation per the designated
Manufacturing Process Procedures. Lamination skills are: flash
route, breakdown, lay up, material preparation, and lamination
press. 2nd shift hours are 3 PM - 11:30 PM
Principal Duties and Responsibilities:
Material Prep: The material prep process is preparing all materials
to be used in the lay-up process.
Process panels per Lamination MPP:
Monitor humidity in material prep room.
Verify requirements of incoming materials to package label.
-(Vendor, correct material, lot number, proper marking, thickness,
Monitor accuracy of materials inventory.
Monitor usage of material by shelf life.
Cut Prepreg, caps, copper foil, and tedlar as required.
Drill lay up holes as necessary.
Lay-up: Lay-up is the process of layering (\\"booking\\") the
detail with the prepreg and the copper foil to create a book that
will be placed in the lamination press.
Process panels per Lamination MPP:
Verify that all necessary materials are available prior to start of
Lay-up panels per lay-up sheet and traveler.
Verify bake cycle of details prior to lay-up.
Clean caul plates with Time Saver.
Monitor to insure uniform and constant flow of work through
Verify humidity of lay-up room.
Measure thickness of finished panels.
Breakdown: The breakdown process is the final step after lamination
to clean and prepare the panel for the next process.
De-pin and breakdown books.
Clean resin from tooling holes, move to flash route for route after
Measure panel thickness using micrometer.
Brush panels for particles.
Lamination Press: In the pressing stage the books are placed into
the lamination press and subjected to extreme heat and pressure.
When subjected to heat and pressure in the lamination cycle the
resin in the prepreg softens, flows, and becomes an adhesive. When
cooled, bonding of the copper foil, details, and prepreg form a
Process panels per Multilayer Lamination MPP:
Verify press calibration.
Verify proper vacuum pressure of press.
Assure proper placement of books in press.
Verify temperature and cycle time per traveler.
Monitor to insure uniform and consistent flow of work through
Perform other duties as assigned.
Job Knowledge, Skills and Abilities:
Able to understand and follow daily work direction and process
instructions from supervisor or other qualified person in
Ability to understand and follow posted procedures.
Ability to understand and follow all safety codes.
Must be able to communicate fluently in English, including basic
reading and writing.
Attention to directions and ability to focus on details
Must be able to regularly lift 50 pounds and carry materials.
Must be able to stand for 8-10 hour shift.
Required Work Experience: 0-2 Years Relevant Experience
Previous PCB experience preferred. Previous PCB lamination
experience highly desired.
Must comply with TTM Export Control Policies and Procedures and all
applicable laws including ITAR, EAR and OFAC including but not
limited to: a) being able to identify ITAR product on the
manufacturing floor and understand that access to these products
and related technical data is restricted to only US Citizens and US
Permanent Residents; b) recognition of Foreign Person visitors by
All qualified applicants will receive consideration for employment
without regard to race, color, religion, sex, sexual origination,
gender identity, national origin, citizenship, disability, or
protected veteran status.
Keywords: TTM Technologies, Denver , Lamination Operator - 2nd shift, Other , Littleton, Colorado
Didn't find what you're looking for? Search again!